Thank you for this nice tip and today i will play arround with mix control and kemper and SPDIF interface hardware output. And there's no obligation to always have the amp/cab block enabled. And there's no Kemper-Police that checks that you only use the Profiler with guitars/basses. if you have a keyboard connected to your interface and you want to add some nice grit and/or rotary/flanger effect to a clean hammond organ sound).Nobody likes to mess around with cables all the time, the MixControl mixer makes it fast and easy to use the Kemper with pretty much everything you want. Applies to: Saffire Range and 1st Generation Scarlett 6i6, 8i6, 18i6, 18i8 and 18i20. : Focusrite Answerbase - if you can get hold of it. chorus, pitch effects, EQ, compressor and all the good stuff of the Profiler to your signal chain. Some FireWire 800-400 adaptors have been seen to cause problems, and as such wed recommend using this Sonnet adaptor - Saffire connection problems with the new Mac range. For example, have you ever used the Profiler as an effects unit for vocals or for mic'ed acoustic guitar? With a dedicated MixControl mixer assigned to the hardware S/PDIF output, it's very easy to send a microphone to the Kemper which allows you to add delay, reverb. but it opens up lots of added possibilities in an easy way. Nobody likes to mess around with cables all the time, the MixControl mixer makes it fast and easy to use the Kemper with pretty much everything you want. if you have a keyboard connected to your interface and you want to add some nice grit and/or rotary/flanger effect to a clean hammond organ sound). chorus, pitch effects, EQ, compressor and all the good stuff of the Profiler to your signal chain. This is the same as as i route DAW5 to the SPDIF 1 output.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |